Apatent application was made in 1981 for the earth shattering invention of "the original – LUX ELEMENTS® hard foam support ELEMENT".
The construction panel for walls and floors LUX ELEMENTS®-ELEMENT
The installation cladding LUX ELEMENTS®-TEC
Bath surrounds LUX ELEMENTS®-TOP
The washstands LUX ELEMENTS LAVADO®
Point drainage LUX ELEMENTS TUB®
Linear drainage LUX ELEMENTS TUB-LINE®
Wellness LUX ELEMENTS®-RELAX
Prefabricated room constructions LUX ELEMENTS®-MODUL
The decorative elements LUX ELEMENTS®-DECO
Individual room constructions LUX ELEMENTS®-CONCEPT
The tried and tested accessories are fully harmonised for processing ELEMENT. Specially developed adhesives and mortars, sealing tapes, mounting angles and plugs ensure problem-free processing.
Fastening sets and dowels LUX ELEMENTS®-FIX
Adhesives LUX ELEMENTS COL®
Sealing filler and sealing tapes LUX ELEMENTS®-DRY
Reinforce LUX ELEMENTS ARM®
Mounting aids LUX ELEMENTS MONT®
LUX ELEMENTS®-...-PLUS Individual, special manufacture for each product group
In addition to standard products, also individually tailored and specially manufactured products are available for the products groups listed under the designation ‘PLUS‘.
Sizes, shapes, thicknesses etc., that deviate from standard features can be inquired from LUX ELEMENTS. After successful verification of implementation possibility at LUX ELEMENTS an appropriate offer will be prepared. Once an order is placed, it will be manufactured and delivered accordingly.
Overview of All Issues
LUX ELEMENTS GmbH & CO KGAn der Schusterinsel 7D - 51379 Leverkusen-Opladen+49 (0) 21 71/ 72 12 - 0 (tel)+49 (0) 21 71/ 72 12 40 (fax)
Prosol Distribution Inc. 165 Rue Deslauriers H4N 2S4 St-Laurent, Québec 001 514 745 1212 (tel) 001 514 745 1215 (fax) firstname.lastname@example.org http://www.prosol.ca/
Current trade fair dates
Carry out a continuous cut on the top side of the ELEMENT construction panel along an applied ruler using the cutter.
A single cut is sufficient for thinner panels (4 mm · 3/16'') to split the construction panel. For thicker panels (6 mm to 20 mm · 1/4'' à 13/16") bend along the cut.
Then use the cutter to sever the mortar layer and the glass fibre fabric on the rear side of the ELEMENT construction panel in its bent state.
Before cutting, draw a cutting line using a pencil and a ruler.
Apply the angle grinder (segmented diamond grinding sheet) and cut through the ELEMENT construction panel along the cutting line (very easy cutting).
A smooth, clean cutting edge is created.
For a clean cut of the ELEMENT construction panel, we recommend a jig saw with a serrated blade (e.g. type Bosch T313AW HCS).
Before the actual cut, draw a cutting line using a pencil and a ruler. Then cut to size along the line of the ELEMENT construction panel using the jig saw (very easy cut).
Thick panels up to 100 mm · 3 15/16" can be cleanly cut using this technique. The jig saw is also particularly suitable for cutting contours and curves.
© 2019 All rights reserved. We reserve the right to make technical changes.Status: Sep 02,2019
Prosol Distribution Inc.
165 Rue Deslauriers
H4N 2S4 St-Laurent, Québec
001 514 745 1212 (tel)
001 514 745 1215 (fax)