Floor applications - Application on beton or screed

1

The shorter Baby construction panels from ELEMENT-EL Baby 10 are suitable for this application.

Irregularities must be compensated using levelling filler. Do not forget the edge insulation strips. Allow the ELEMENT panels to adapt to ambient conditions such as temperature and humidity prior to installation.

2

The substrate must be load-bearing and vibration-free.

After preparation of the substrate, stick edge insulation strips circumferentially round all wall-floor connections.

3

Apply COL-AK fixing adhesive with a toothed trowel (depending on the substrate, at least 6 mm · 1/4'') to evenly cover the surface.

4

The ELEMENT panels are positioned close together in bond and pressed into the adhesive layer.

5

Dot laying is possible from EL 30. The spacing of the mortar dots should be approx. 20 cm · 7 7/8" .

6

Reinforce ELEMENT joints with ARM-100 SK ...

7

... and level out with COL-AK. Use the fluidised thin bed adhesive COL-FBK or COL-FLEX for the cavity-free installation of tiles.

NOTE: When applying in damp or wet rooms it is necessary to use an additional LUX ELEMENTS®-DRY-ASK or DRY-DF sealing in conjunction with ceramic coverings. Use the fluidised thin bed adhesive COL-FBK or COL-FLEX for the cavity-free installation of tiles.

A total pressure load of 0,1 N/mm² must not be exceeded.
When using for higher loads such as transport traffic, rack
systems etc., please contact the LUX ELEMENTS technical department.

Also suitable for heating systems due to continuous temperature resistance up to +75°.

powered by webEdition CMS